Weaving a belt

1. Getting Started
Start by anchoring the cord to the belt.

image001

Measure off the desired length and loop the cord back. I like to loop the other end to a carbiner, as it can easily be slipped off later, and fix it with an elastic band or a knot.

image002

Bring the two strands back to the buckle. Note that one strand comes out from under the buckle and the other goes in from above, this is very important. Just to be clear, I shall refer to the four strands that extend straight between the buckle and the carbiner as the spine or spine strands, and the two free strands as the weaving strands.

image003

2. Loop Back
I call this step looping back. Weave each weaving strand around the two spine strands on it’s side, then back out, as in the photo.

image004

Now tighten: hold or anchor the spine strands and pull the woven loops towards the buckle while pulling the weaving strands to remove the slack. In general I think it’s a good idea to pull the weaving strands tight in this step to help pull the two central spine strands apart.

image005

3. The Crossover
Now comes the crossover. Take one of the weaving strands and weave it through the four spine strands, treating the two central strands as if they were one strand. Don’t pull tight yet.

image006

Now do the same with the other weaving strand, but cross the first weaving strand while passing the two central spine strands, as in the photo.

image006

As you can see the weaving strands have now crossed sides. Pull the woven loops down to the belt again, but don’t pull too tight on the weaving strands this time or else the ‘holes’ in the belt will be too tight and closing the buckle will be difficult.

image008

4. Rinse and Repeat
Keep repeating the crossover and loop back steps until you reach the end of the belt. As you can see in the photo you have gaps in the center of the belt where it’s possible to push through the prong of the buckle. You don’t have to weave one-to-one; you could use two crossover rows for each loop back row, or two loop back rows to make a larger hole that’s easier to push the prong through, whatever works for you.

image009

5. Finish
When you reach the loops at the end of the spine, slide off the elastic band and carbiner, keep weaving until you pass the weaving strands through the cord for the final time, then cut the ends off, melt the tips, and… do something with them. I didn’t actually finish this belt as I soon realised that the belt was too wide to fit through the buckle. I’ll need to get a slightly larger buckle and try again, then I’ll figure out the best way to handle the ends of the cord.

Geef een reactie

Vul je gegevens in of klik op een icoon om in te loggen.

WordPress.com logo

Je reageert onder je WordPress.com account. Log uit / Bijwerken )

Twitter-afbeelding

Je reageert onder je Twitter account. Log uit / Bijwerken )

Facebook foto

Je reageert onder je Facebook account. Log uit / Bijwerken )

Google+ photo

Je reageert onder je Google+ account. Log uit / Bijwerken )

Verbinden met %s